HomeHome  PortalPortal  CalendarCalendar  GalleryGallery  FAQFAQ  RegisterRegister  Log inLog in  

Share | 

 Spider Web Shade install

Go down 
Poster child
Poster child

Number of posts : 243
Age : 45
Location : Oahu
Rig : 2007 JK Rubicon Unlimited
specs. : 3.5" RK X Factor Mid-Arm lift, 35x12.5x16 MTR/Ks, 16 inch Pro Comp 7069s, Genright Armor
Registration date : 2011-04-01

PostSubject: Spider Web Shade install   Sun 16 Dec 2012, 11:58 pm

Installed the Gray/Silver SpiderWebShade today....a gift from some good friends for letting them borrow my Jeep for a few weeks when they had to ship their Jeep back to Virginia from Oahu! Smile This top is awesome! Works with soft tops, hard tops or by itself and doesnt need to be removed when putting up or on the other tops. You can put it in place and leave it! Very Happy

This first picture shows a little wave in the top but was still adjusting it....just wanted to show I was still able to put it on without taking the hard top off! I had to take out the front two mounting bolts and loosen the 6 interior retaining bolts (dont need to completely remove) and then I could lift the top enough to slide the mesh top through:

Back to top Go down
View user profile
Spider Web Shade install
Back to top 
Page 1 of 1
 Similar topics
» Spider Wire Braid
» HID Conversion Kit Install Instructions
» Rhino 660 Speedo Install
» Ranger Clutch Kit install, RZR mostly the same
» Hunterworks stage I cam install test results.....

Permissions in this forum:You cannot reply to topics in this forum :: JEEP TECH :: Write-up's & How-to's-
Jump to: